5V 40A Slim Switching Power Supply 200W(Economy)

High efficiency and low operation temperature.

Soft-start current can reduce the AC input impact effectively.

PWM control and regulation.

Installed with EMI filter, minimum wave.

Low price and high reliability.

High-performance use for P10 display module.

LED Display Power Supply 200W  (C&V)
1.  Ultra thin design 198*82*30mm
2.  IP20 design for indoor installation
3.  Protections:short circuit/over load/over voltage/over temperature
4.  100% full load burn-in test
5.  Two years warranty
6.  Applicable to Small spacing/Special screen/Transparent screen/Die-casting box.
MODEL  LED POWER SUPPLY  HA-5V 200W (Single color)  HB-5V 200W (Full color)  HC-5V 200W (Wide voltage)
OUTPUT  Output voltage  5V DC  5V DC  5V DC
  Output voltage range  5VDC±0.5VDC  5VDC±0.5VDC  5VDC±0.5VDC
  Output Current  Max 40A  Max 40A  Max 40A
  Output power  Max 200W
  Output power range  0~200W
  Ripple & Noise  ≤150mV
  Linear Regulation  ±1%
  Load Regulation  ±1%
  Start-up Time (Typ)  50ms/230VAC
  Hold Up Time(Typ)  200ms/230VAC
INPUT  Input voltage  200-240Vac  110-240VAC
  Frequency  50/60Hz
  Input сurrent  1.76A/230Vac
  Power factor  PF>0.8
  No-load power consumption  <3W
  Efficiency (typ.)  89%  89%
  Inrush current(typ.)  Cold start 60A at 230Vac
  Control surge capability  L,N:2KV L,N-PE:4KV
  Leakage сurrent  Max. 0.5mA
ENVIRONMENT  Working temperature  ta: -30°C~ 50°C tc: 80°C
  Working humidity  20 ~ 99%RH, condensing (Waterproof)
  Storage temp., humidity  -40°C ~ 80°C, 10~95%RH
PROTECTION  Overtemperature  Protection type: Turn off the output voltage, after the temperature drops, re-energize to restore.
  Over load protection  Shut down the output when current load above 110%~150%, auto recovers.
  Short circuit protection  Protection type: It can be automatically restored after the fault is eliminated.
SAFETY&EMC  Withstand voltage  I/P-O/P:3750Vac
  Isolation resistance  I/P-O/P: 100MΩ/500VDC/25°C/70%RH
  Safety standards  IEC/EN61347;IEC/EN60950;IP67
  EMC Test Standards  EN55015: 2013;EN61547: 2009; EN61000-3-2:2014; EN61000-3-3:2013
Reliabilityand Quality Control  Impact aging  100% of the product is fully loaded and impacted for 4 hours under an environment of at least 40°C±5°C
  Component derating  Under the steady-state conditions of rated input and output, the stress of components will not exceed its maximum nominal value
NOTE1.All parameters not specifically mentioned are measured at 230VAC input, rated load and 25°C ambient temperature.
2.Ripple and noise test method: connect 0.1uF and 47uF capacitors in parallel at the terminal, and measure under 20MHZ bandwidth.
3.Ensure that the power supply is used under the rated parameters and environment.

With more than 18 years of manufacturing and exporting experience in switching power supplies, MIJI can provide import guides and professional reports for purchasing and product suggestions for your market! Contact us for free samples.