12V 10A Switching Power Supply 120W

Item Type: Switch Power Supply Driver

Material: Aluminum alloy

Output: DC 12V

Working Temperature: 0~40℃

Storage Temperature: -20~60℃

Environmental Humidity: 0~95% non-condensing

Applicable To: Industrial automation, LED display, CCTV, radio, computer engineering, LED light bar, printer, LED strip, led module, led pixel, LED rigid bar, etc.

Switching Mode Power Supply 120W  (C&V)
1. Protections:Short circuit/ Overload/Over voltage
2. Cooling by free air convection
3. LED indicator for power on
4. 100%full load burn-in test
5. All using 105°C long life electrolytic capacitors
6. Withstand 300VAC surge input for 5 second
7. High efficiency,long life and high reliability
MODEL  LED POWER SUPPLY  S-12V 120W  S-24V 120W
OUTPUT  Output voltage  12V DC  24V DC
  Output voltage range  12VDC±0.5VDC  24VDC±0.5VDC
  Output Current  Max 10A  Max 5A
  Output power  Max 100W
  Output power range  0~100W
  Ripple & Noise  ≤200mV  ≤200mV
  Linear Regulation  ±2%
  Load Regulation  ±1%
  Start-up Time (Typ)  50ms/230VAC
  Hold Up Time(Typ)  20ms/230VAC
INPUT  Input voltage  200-240Vac
  Frequency  50/60Hz
  Input сurrent  0.35A/230Vac
  Power factor  PF>0.6
  No-load power consumption  <3W
  Efficiency (typ.)  82%  84%
  Inrush current(typ.)  Cold start 50A at 230Vac
  Control surge capability  L,N:2KV L,N-PE:4KV
  Leakage сurrent  Max. 0.5mA
ENVIRONMENT  Working temperature  ta: -30°C~ 50°C tc: 80°C
  Working humidity  20 ~ 99%RH, condensing (Waterproof)
  Storage temp., humidity  -40°C ~ 80°C, 10~95%RH
PROTECTION  Overtemperature  Protection type: Turn off the output voltage, after the temperature drops, re-energize to restore.
  Over load protection  Shut down the output when current load above 110%~150%, auto recovers.
  Short circuit protection  Protection type: It can be automatically restored after the fault is eliminated.
SAFETY&EMC  Withstand voltage  I/P-O/P:3750Vac
  Isolation resistance  I/P-O/P: 100MΩ/500VDC/25°C/70%RH
  Safety standards  IEC/EN61347;IEC/EN60950;IP67
  EMC Test Standards  EN55015: 2013;EN61547: 2009; EN61000-3-2:2014; EN61000-3-3:2013
Reliabilityand Quality Control  Impact aging  100% of the product is fully loaded and impacted for 4 hours under an environment of at least 40°C±5°C
  Component derating  Under the steady-state conditions of rated input and output, the stress of components will not exceed its maximum nominal value
NOTE1.All parameters not specifically mentioned are measured at 230VAC input, rated load and 25°C ambient temperature.
2.Ripple and noise test method: connect 0.1uF and 47uF capacitors in parallel at the terminal, and measure under 20MHZ bandwidth.
3.Ensure that the power supply is used under the rated parameters and environment.

With more than 18 years of manufacturing and exporting experience in switching power supplies, MIJI can provide import guides and professional reports for purchasing and product suggestions for your market! Contact us for free samples.